News

News

News


2nd IPPT_TWINN workshop - Injection molding and rapid tooling, May 2023
/ Categories: News

2nd IPPT_TWINN workshop - Injection molding and rapid tooling, May 2023

The workshop was opened on the 11th of May with theoretical basics with  Dr. Bela Zink holding presentation on Injection moulding background, followed by presentation of Krizsma Szabolcs titled Trends in soft mould (RPT). After theoretical introduction, lab tour was conducted, where all the labs and equipment were presented. In the afternoon practical training begun with Injection moulding, sensors, and measurements in the mould workshop. On the second day (12th of May), 3 more practical trainings on Prototype injection moulding, Injection Moulding with Prototype moulds and Prototype moulds with sensors and deformation measurement were held.

Previous Article Presentation of IPPT_TWINN at International Symposium on Smart Materials
Next Article 4th IPPT_TWINN workshop - Design for injection moulding

Name:
Email:
Subject:
Message:
x

Newsletters

3rd Newsletter

The 3rd IPPT_TWINN newsletter is issued. It summarizes the project activities in the period from January to July 2024. 

 

2nd Newsletter

The 2st IPPT_TWINN newsletter is issued. It summarizes the project activities in the period from June to December 2023. 

 

1st Newsletter

The 1st IPPT_TWINN newsletter is issued. It summarizes the project activities in the period from January to June 2023.